Audio-Technica AT2020 vs Shure SM58 for bedroom vocals: which fits your setup?
Short answer: Choose the AT2020 XLR for a fixed stand-mounted recording setup when you have a suitable microphone preamp, 48 V phantom power and a workable room/recording position. Consider the Shure SM58 when a close-address handheld or stand-mounted vocal workflow and its integrated pop filter suit your performance. It does not need phantom power. Neither automatically removes room noise or sounds universally better. If your existing microphone already records cleanly enough for the intended project, you may not need either.
These are the conventional XLR versions of the AT2020 and SM58, not an AT2020USB variant, a Shure SM58S switch variant or a generic condenser-versus-dynamic contest. Before buying, compare the actual microphone position, voice-to-room balance, powering, preamp gain and complete recording chain.
Four decisions to make before you pick a microphone
This comparison is a narrow two-product buying decision. For the broad operating-principle comparison, see Dynamic vs Condenser Microphone. For deciding between USB and an analog XLR chain, use USB vs XLR Microphone for Home Recording.
AT2020 vs SM58: verified microphone differences
| Published detail | Audio-Technica AT2020 XLR | Shure SM58 (standard wired) |
|---|---|---|
| Transducer | Fixed-charge condenser | Moving-coil dynamic |
| Polar pattern | Cardioid | Cardioid |
| Frequency response (published span) | 20 Hz–20 kHz | 50 Hz–15 kHz |
| Connector | Balanced 3-pin XLR | 3-pin XLR |
| Phantom power | Requires 48 V DC | Not required for its passive moving-coil operation |
| Physical vocal orientation | Side-address: sing toward the manufacturer's marked/front side | End-address: sing toward the grille |
| Published output sensitivity at 1 kHz | −37 dBV/Pa (14.1 mV at 1 Pa) | −56 dBV/Pa (1.6 mV at 1 Pa) in Shure's current online manual |
| Included basic accessories | Stand mount and soft protective pouch | Stand adapter and storage bag; built-in spherical pop filter |
The numbers come from Audio-Technica's exact AT2020 data sheet and Shure's SM58 manual. The sensitivity figures describe published output voltage under a specified sound pressure, not relative quality, studio “detail,” isolation or audible noise at equal recorded level. Other Shure edition-specific PDFs list slightly different SM58 sensitivity figures; consult the exact revision in use rather than treating the last decimal as a buying verdict.
Important: the AT2020's 20 Hz–20 kHz specification and the SM58's 50 Hz–15 kHz specification are broad published response limits. They do not tell you which sounds better on your voice or how either frequency response behaves at every frequency and angle.
Will the SM58 pick up less bedroom noise than the AT2020?
Not automatically. Both are cardioid microphones, with reduced sensitivity to sounds from the sides and rear compared with the front. Their designs and off-axis frequency responses can differ, but a dynamic capsule is not an acoustic noise gate. Setting up both in the same position and adjusting gain to achieve a comparable voice level does not magically make a loud fan, traffic or room reflection disappear from the SM58 recording.
What can make a meaningful practical difference is microphone distance and direction. Shure's SM58 guide explicitly describes close singing toward the grille, including placements under 15 cm (6 in.). Moving the wanted voice closer to a microphone while leaving distant noise sources where they are can improve the balance of direct voice relative to room sound. That is a source-distance advantage of a workable technique, not a blanket claim that dynamic microphones reject sound better at all matched positions.
The AT2020 is a side-address cardioid microphone; its own document says to aim the marked front face toward the source. It, too, can be positioned deliberately to favor the voice while reducing the contribution of off-axis sounds. However, moving a singer close to any cardioid microphone can change bass response, breath noise and plosives. The correct distance is a trade-off, not an automatic “as close as possible” rule.
Shure's directionality explainer and placement guide explain why polar pattern, distance and the location of unwanted sound matter. Neither source provides a model-matched room-noise measurement proving a universal winner between these two mics. Do not confuse the SM58's low output sensitivity with acoustic suppression of background sound.
Plan recording around the room you actually haveStudio Builder considers your recording goal, room, constraints and existing gear before suggesting supported catalog candidates. Live pricing and arbitrary USB/DAW microphone compatibility are not independently verified.48 V phantom power, preamp gain and the total signal chain
Both microphones have standard XLR outputs and need a suitable microphone input and computer recording path. If you intend to record them into a laptop, verify you have an interface or another compatible microphone preamp/converter, the right XLR cable and usable monitoring. The microphone's physical XLR connector is not a USB audio interface.
AT2020: Audio-Technica specifies 48 V DC phantom power. Confirm the exact interface can supply it to the correct mic input and follow the manufacturer's connection procedure. Without the documented supply, this XLR condenser is not a plug-and-play computer mic.
SM58: the passive moving-coil microphone does not require phantom power to work. Shure's published output sensitivity is lower than AT2020's, so the interface may need more gain to reach the same digital recording level for a comparable sound pressure. The amount of clean usable gain, your actual singing level and distance must be checked with the specific interface. Do not automatically add an inline booster or replace an interface because someone called this mic “gain-hungry.”
If the interface powers multiple microphones together, check its documented phantom switching behavior before connecting sensitive or unconventional equipment. For the power rule and safe switching sequence, read 48V Phantom Power. For recording level rather than a product purchase, see How to Set Input Gain Without Clipping.
Four bedroom-vocal situations that change the decision
1. Rap or close-address lead vocals with an audible room
If you perform consistently very near the mic, an SM58-style grille and close vocal technique may be convenient. You can experiment with positioning the mic so that unwanted sources approach its less-sensitive directions. Listen for plosives, proximity-related low-frequency buildup and handling noise. The SM58's built-in filter helps with some breath/pop sounds but does not guarantee plosive-free takes.
2. A reasonably quiet bedroom and a fixed vocal stand
AT2020 can be a valid candidate if your interface supplies 48 V, you can position the marked front toward the singer, and the room or recording position is workable. It is not proven “more detailed on every voice” from its response range alone. Arrange a practical pop-filter solution if breath plosives are a problem, and evaluate your own recorded source rather than listening only to unrelated online audio samples.
3. Fan noise and reflective bare walls
Before buying either mic, identify whether the obstacle is a noisy computer, an open window, a strong nearby reflective surface or another source. Move/quiet the noise source where practical, change the recording time, move the mic/singer or use appropriate temporary absorption without creating unsafe equipment conditions. Record another test. Replacing a microphone without changing the room does not eliminate sound that reaches the capsule.
4. You own a working Scarlett Solo or 2i2 already
Both fourth-generation Scarlett models have a documented XLR mic preamp and 48 V supply for condenser microphones. The SM58 can use the mic input without needing phantom power; AT2020 requires the supported 48 V mode. Your microphone fit still depends on source level, desired position and actual gain settings. If your current mic and interface already work for the project, keeping them is an acceptable decision. For the separate interface-channel question, use Scarlett Solo vs 2i2 4th Gen.
A no-purchase test before committing to either model
- Define the use: one voice at a time, handheld performance, fixed vocal booth, or a simultaneous second mic. The number of microphones in one take may affect your interface decision.
- Map the room: identify fan/traffic/electrical noise and reflective surfaces. Check if quieting or repositioning is possible and safe.
- Verify the path: exact XLR input, clean gain range, cable, headphone monitoring, OS/DAW route and 48 V phantom if considering AT2020.
- Compare positioning: AT2020 uses its marked side; SM58 uses its end grille. Hold or mount them in a repeatable position. Do not conflate a louder preamp setting with a noisier acoustic pickup pattern.
- Listen to your own source: use a comparable performance, recorded level and room conditions before deciding whether a new mic solves the relevant constraint. No listening result in this article is claimed as personally tested.
- Budget the entire setup: mic, stand/mount, XLR cable, possible pop filter, supported interface/phantom power, and monitoring. This page does not invent current prices, inventory or a “winner under $100.”
If the wider setup is uncertain, start with Home Studio Planning and then Studio Builder. For a concrete already-identified catalog product, use the Product Checker within its documented compatibility limits.
Frequently asked questions
Is the Shure SM58 better for an untreated bedroom?
Not universally. SM58's close-vocal form and built-in grille can make close positioning practical, improving direct voice relative to distant room sources. But both microphones are cardioid and neither cancels room noise. The best workable choice depends on your singer position and noise sources.
Does the Audio-Technica AT2020 need 48 V phantom power?
Yes. The conventional XLR AT2020 model documented here requires 48 V DC phantom power. Do not confuse it with products labelled AT2020USB, which have a different connection and power path.
Can I plug an SM58 or AT2020 straight into my laptop?
Neither standard XLR microphone directly supplies computer-ready USB audio. Plan a compatible microphone input, preamp and analog-to-digital conversion path, normally provided by a suitable audio interface.
Does the AT2020 automatically record more vocal detail?
Published sensitivity and frequency-response ranges are not controlled voice recordings. Without a real matched comparison, no universal detail, warmth or sound-quality winner can be established.
Should I replace an SM58 I already own with an AT2020?
Only if you have an identified, demonstrable recording limitation and the new mic, room, power supply and technique address it. Do not upgrade solely because one is called a studio condenser.
What Makelyo can and cannot verify
Makelyo Studio ranks verified catalog candidates from the listener's goal, room, existing equipment and documented compatibility needs, not affiliate revenue. It can expose retailer-neutral buying paths when exact product evidence exists. It cannot certify the sound of either microphone on your voice, acoustic noise rejection at your position, every electrical mic/interface pair, current prices, availability or a complete priced checkout build. Respect manufacturer documentation before buying.
Primary sources and how this guide was prepared
This is an AI-assisted, source-checked Makelyo Studio buying-decision guide, not an independent microphone listening test. Specs were checked against the actual Audio-Technica AT2020 XLR data sheet and Shure SM58 user manual on October 14, 2026. No hands-on test, recorded comparison, review score, popularity, current offer, paid endorsement or merchant inventory has been invented.
- Audio-Technica — AT2020 XLR official data sheet, 48 V requirements and source orientation.
- Shure — SM58 official user guide, pickup pattern, sensitivity, pop filter and close-vocal placement.
- Shure — Microphone Directionality and Polar Pattern Basics.
- Shure — Three Reasons Why Mic Placement Matters.